Filters-Bias Tees-Diplexers

Bias Tee Description The BIT-1500-385 is a Bias Tee network used to supply DC power through a coaxial cable, usually to drive a remote Low Noise Amplifier or Radio Frequency system (sensor, detector, etc.) It is a 3 port (connector) device, each port carrying the following signals: (1) RF+DC, (2) DC only and (3) RF only. Port (1) is connected to the remote device, providing it with power and with a means to deliver an RF output simultaneously. Although both signals share the same coaxial...

ISM/LTE/Cellular-GNSS/GPS Diplexer description DPLU-1200-673 Diplexer, separates GNSS (Global Navigation Satellite System) or GPS (Global Positioning System) signals from Sub-GHz band signals, such as ISM (432/868/915 MHz), LTE (700 MHz) and Cellular (800/900 MHz), enabling a single coaxial cable to carry both signals, or permitting the use of a single wideband or multi-function antenna capable of supporting both spectra and services. Two Diplexers may be used at each end of a long, low-loss...

LTE/GSM/Cellular Diplexer description DPLU-1400-673 Diplexer, separates Low and High LTE (Long-Term Evolution 700/1700-2100 MHz), GSM (Global System for Mobile Communications' 900/1800 MHz) or Cellular/Personal Communications System (800/1900 MHz) signals, enabling a single coaxial cable to carry both signals, or permitting the use of a single wideband or multi-function antenna capable of supporting both spectra and services. Two Diplexers may be used at each end of a long, low-loss coaxial...

GNSS/GPS-Bluetooth/2.4 GHz Diplexer description DPLU-2000-673 Diplexer, separates GNSS (Global Navigation Satellite System) or GPS (Global Positioning System) signals from 2.4 GHz band signals, such as Bluetooth, Zigbee and Wi-Fi, enabling a single coaxial cable to carry both signals, or permitting the use of a single wideband or multi-function antenna capable of supporting both spectra and services. Two Diplexers may be used at each end of a long, low-loss coaxial cable to transport both...

GNSS/GPS/2.4 GHz-CBRS/3.5 GHz Diplexer description DPLU-3000-673 Diplexer, separates GNSS (Global Navigation Satellite System) or GPS (Global Positioning System), LTE, GSM, Bluetooth, Zigbee, Cellular and 2.4 GHz Wi-Fi signals from 3.5 GHz CBRS (Citizens Broadband Radio Service), WiMax and 5 GHz Wi-Fi signals, enabling a single coaxial cable to carry both or more signals, or permitting the use of a single wideband or multi-function antenna capable of supporting both spectra and services. Two...

GNSS/GPS-C-band/5 GHz Diplexer description DPLU-3500-673 Diplexer, separates GNSS (Global Navigation Satellite System) or GPS (Global Positioning System) signals from 5 GHz band signals, such as C-band, UNII and Wi-Fi, enabling a single coaxial cable to carry both signals, or permitting the use of a single wideband or multi-function antenna capable of supporting both spectra and services. Two Diplexers may be used at each end of a long, low-loss coaxial cable to transport both signals between...

Wi-Fi Diplexer description DPLU-4000-673 Diplexer, separates both bands comprised in Wi-Fi signals, namely 2.4 GHz and 5 GHz (Wi-Fi 6 compatible), enabling a single coaxial cable to carry both signals, or permitting the use of a single wideband or multi-function antenna capable of supporting both spectra and services. Two Diplexers may be used at each end of a long, low-loss coaxial cable to transport both signals between two dedicated radios and antennas. Diplexers are bidirectional and...

UHF Satcom MUOS Diplexer description DPLU-0310-680 MUOS Diplexer, isolates new MUOS Downlink (RX) signals from Uplink transmitted energy. It also manages Legacy and Modern waveforms available from MUOS payloads, enabling a single antenna to support all UHF Satcom modes supported by existing field radios. Currently, a separate RF connector is required for the MUOS WCDMA downlink. This Diplexer supports such requirement. Diplexers are bidirectional and linear. This means that the direction of a...

As of May 2007, this filter model has been upgraded to Revision A, to incorporate the following improvements: greater out of band isolation, increased current handling capability to 1 Ampere, built-in protection fuse which automatically resets itself (more detail below) voltage drop through the filter has been reduced to 1/7th that of the original design (for greater power efficiency) FILTERS NOW INCLUDE A FUSE THAT RESETS AUTOMATICALLY and you may select from 4 different fuse currents. This...

As of May 2007, this filter model has been upgraded to Revision A, to incorporate the following improvements: greater out of band isolation, increased current handling capability to 1 Ampere, built-in protection fuse which automatically resets itself (more detail below) voltage drop through the filter has been reduced to 1/7th that of the original design (for greater power efficiency) FILTERS NOW INCLUDE A FUSE THAT RESETS AUTOMATICALLY and you may select from 4 different fuse currents. This...

NSN No. 5985016309033 As of May 2007, this filter model has been upgraded to Revision A, to incorporate the following improvements: greater out of band isolation, increased current handling capability to 1 Ampere, built-in protection fuse which automatically resets itself (more detail below) voltage drop through the filter has been reduced to 1/7th that of the original design (for greater power efficiency) FILTERS NOW INCLUDE A FUSE THAT RESETS AUTOMATICALLY and you may select from 4 different...

As of May 2007, this filter model has been upgraded to Revision A, to incorporate the following improvements: greater out of band isolation, increased current handling capability to 1 Ampere, built-in protection fuse which automatically resets itself (more detail below) voltage drop through the filter has been reduced to 1/7th that of the original design (for greater power efficiency) FILTERS NOW INCLUDE A FUSE THAT RESETS AUTOMATICALLY and you may select from 4 different fuse currents. This...